Belt Guide
Everything you need to know to wear, adjust, and customize your Solenna belt.
A quick fitting note before you start: Start with the square end — this is the side that goes into the buckle and can be trimmed if needed, while the pointed end stays beautifully finished.
Choose your look
Pick your buckle, pair it with the strap you want, then insert the square end of the strap into the buckle clasp and close it securely.
Important: Attach the buckle to the square end of the strap, not the pointed end. Make sure the buckle clasp and the strap’s trackline are on the same side, then close the clasp securely. To remove the buckle, simply lift the clasp. If it feels a little tight, use a small stick or similar tool to gently pry it open.
Slide it on
Feed the pointed end through your belt loops and into the buckle when you wear the belt.
Pull to fit
Gently pull the strap until it clicks into place and feels comfortable. If the buckle locks securely, the strap length is right. If the buckle does not lock and the belt feels too loose, see Step 5 to trim a little more from the strap.
Release easily
Press the small lever on the buckle to loosen or remove the belt. Depending on which direction you thread the strap through your belt loops, the lever may sit on the top or bottom. It works the same either way.
Trim to your length
The strap is designed with extra length, so you can wear it as is or trim it gradually for your preferred fit. Measure it around your waist first, then trim a little at a time from the square end. To reattach the buckle, simply secure it back onto the newly trimmed end.
Trim from the square end only. The square end is designed to go inside the buckle clasp and can be trimmed for a custom fit. Do not trim the pointed end, it is the finished side that slides through the buckle when you wear the belt.
